Generation   Home

Suspension • Wheel and Tire System • Tire Pressure Monitoring System • Installation 2015 Subaru Forester

generation: → 2011 - 2016Release year → 2015 ✔ engine size → 2L ✔      add to compare      read later

WHEEL AND TIRE SYSTEM > Tire Pressure Monitoring System

INSTALLATION

1. TRANSMITTER (TIRE INFLATION PRESSURE SENSOR)

CAUTION:

Use the new transmitter assembly or replace the new valve and screw, when installing.

1. Replace the valve and screw with a new part when reusing transmitter.

2015 Subaru Forester Suspension • Wheel and Tire System • Tire Pressure Monitoring System • Installation

(1)

Screw

(2)

Transmitter

(3)

Valve

Tightening torque:

1.4 N·m (0.14 kgf-m, 1.0 ft-lb)

2. Install the transmitter to the wheel by aligning it with valve hole.

NOTE:

When using the jig that pulls the valve cap by hooking its neck part, use another short-type cap.

3. Install the tires to wheels.

CAUTION:

• Use a tire changer when installing tire to wheel.

• To prevent damaging the transmitter, set the tire changer boom in the position as shown in the figure.

2015 Subaru Forester Suspension • Wheel and Tire System • Tire Pressure Monitoring System • Installation

(1)

Transmitter

(2)

Direction of turn table rotation

(3)

135°

(4)

Tire changer boom

(5)

90°

(6)

Starting point for fitting the bead to the rim

4. Install the wheels to vehicle.WHEEL AND TIRE SYSTEM > Tire and Wheel > INSTALLATION

5. Register the transmitter ID when the transmitter has been replaced.TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Register Transmitter (ID)

2. TPMS & KEYLESS CONTROL MODULE

1. Install each part in the reverse order of removal.

Tightening torque:

13 N·m (1.33 kgf-m, 9.6 ft-lb)

2. Re-register the transmitter ID and the keyless transmitter when the TPMS & keyless control module has been replaced.

• Register transmitter ID TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Register Transmitter (ID)

• Keyless transmitter registration SECURITY AND LOCKS > Keyless Transmitter > REPLACEMENT

3. TPMS MODULE

1. Install each part in the reverse order of removal.

Tightening torque:

7.5 N·m (0.76 kgf-m, 5.5 ft-lb)

2. Re-register the transmitter ID when the TPMS module has been replaced. TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Register Transmitter (ID)

    2017-02-20 18:50:42    2017-06-19 10:25:05




I advise you to watch 2011 - 2016

© 2018. suforester.com
Order call back