Generation   Home

Steering • Power Assisted System (Power Steering) • Tilt Steering Column • Installation 2008 Subaru Forester

generation: → 2008 - 2010Release year → 2008 ✔ engine size → 2.5L ✔      add to compare      read later

POWER ASSISTED SYSTEM (POWER STEERING) > Tilt Steering Column

INSTALLATION

1. Set the grommet to the toe board.

2008 Subaru Forester Steering • Power Assisted System (Power Steering) • Tilt Steering Column • Installation

2. Insert the end of the steering shaft into the toe board grommet.

3. Tighten the steering shaft mounting bolts under instrument panel.

Tightening torque:

25 N·m (2.5 kgf-m, 18.1 ft-lb)

4. Connect all the connectors under the instrument panel.

5. Connect the airbag system connector at the harness spool.

NOTE:

Make sure to apply double lock.

6. Install the lower column cover with tilt lever held in the lowered position.

7. Install the universal joint. POWER ASSISTED SYSTEM (POWER STEERING) > Universal Joint > INSTALLATION

8. Align the center position of the roll connector. AIRBAG SYSTEM > Roll Connector > ADJUSTMENT

9. Install the steering wheel. POWER ASSISTED SYSTEM (POWER STEERING) > Steering Wheel > INSTALLATION

CAUTION:

Insert the roll connector guide pin into the guide hole on lower end of steering wheel surface to prevent damage.

10. Install the airbag module to the steering wheel.

WARNING:

Always refer to “Airbag System” before performing the service operation. AIRBAG SYSTEM > General Description > CAUTION

    2017-02-20 18:50:38    2017-06-19 10:25:05




I advise you to watch 2008 - 2010

© 2019. suforester.com
Order call back