Generation   Home

SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Removal 2015 Subaru Forester

generation: → 2011 - 2016Release year → 2015 ✔ engine size → 2L ✔      add to compare      read later

SEAT BELT SYSTEM > Front Seat Belt

REMOVAL

1. SEAT BELT OUTER - FRONT

CAUTION:

• The airbag system is fitted with a backup power supply. After disconnecting the battery ground cable, the airbag may operate if you do not wait for 60 seconds before starting the service of airbag system.

• Airbag system satellite safing sensor is located in the lower of the rear seat cushion center. Before removing the rear seat, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM” section.AIRBAG SYSTEM > General Description > CAUTION

• Do not drop or subject the pretensioner to any impact.

• Since the pretensioner and bracket are integrated as a unit, do not disassemble them.

1. Before working, turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 60 seconds or more.

2. Tilt the front seat backrest assembly forward, and move the front seat all the way forward.

3. Release the claws, and then remove the cover side sill - front INN. (On the side where seat belt assembly is removed)

CAUTION:

Do not pull with excessive force. Doing so may damage the claws of the cover side sill - front INN.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Removal

4. Remove the rear seat cushion assembly.

(1) Push the corners of the seat cushion from above.

(2) While pushing the corners of the seat cushion from above, pull the knob of the hook - seat cushion rear towards yourself.

(3) While pulling the knob towards yourself, disconnect the hooks by lifting up the rear seat cushion.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Removal

(4) Remove the hook (A) by pushing it back while lifting the front side of the rear seat cushion, and remove the rear seat cushion.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Removal

5. Release the clips and claws, and then remove the cover side sill - rear INN. (On the side where seat belt assembly is removed)

CAUTION:

Do not pull with excessive force. Doing so may damage the claws of the cover side sill - rear INN.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Removal

6. Remove the trim panel - center pillar LWR. (On the side where seat belt assembly is removed)

(1) Release the clip by pulling the trim panel - center pillar LWR toward you.

(2) Expand the claws of the trim panel - center pillar LWR outward, and remove it from the trim panel - center pillar UPR.

CAUTION:

Do not expand the trim panel - center pillar LWR excessively. Doing so may damage the trim.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Removal

NOTE:

First release the claw located to the front of the vehicle.

7. Remove the adjuster anchor cover and bolts of the trim panel - center pillar UPR, and remove the shoulder anchor. (On the side where seat belt assembly is removed)

8. Remove the seat belt outer - front.

(1) Turn over the floor mat to disconnect the belt tension sensor connector.AIRBAG SYSTEM > Airbag Connector > PROCEDURE

NOTE:

Also disconnect the connector of the passenger’s lap seat belt pretensioner.

(2) Remove the bolt to remove the seat belt retractor.

(3) Remove the lower anchor bolt, and remove the seat belt outer - front.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Removal

2. SEAT BELT INNER - FRONT

CAUTION:

The airbag system is fitted with a backup power supply. After disconnecting the battery ground cable, the airbag may operate if you do not wait for 60 seconds before starting the service of airbag system.

1. Turn the ignition switch to OFF.

2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.

NOTE:

• For the seat with lifter, set the height to the middle position.

• For the power seat, remove the slide rail installing bolt before removing the battery ground.

3. Remove the front seats.

(1) Tilt the backrest assembly forward and move the front seat to the mid point on the slide rail.

(2) Remove the bolts on the front side of the front seat.

(3) Remove the cover - bolt rear.

(1) While spreading the tip of the cover - bolt rear OUT side to side, pull it out toward you to remove.

(2) Remove the cover - bolt rear INN.

NOTE:

• Firmly push in the cover - bolt rear INN at the point shown in the figure until a clicking sound is heard and remove it.

• If it is difficult to remove, release the claw using a flat tip screwdriver wrapped with protection tape while pushing the point shown in the figure to remove.

(4) Remove the bolts on the rear side of the front seat.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Removal

(5) Disconnect the connector under the front seat.

CAUTION:

For the power seat, check that the battery ground cable is disconnected. If not, disconnect the battery ground cable and wait for 60 seconds or more.

• Seat belt warning light connector

• Occupant detection system harness connector (passenger’s seat) OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Airbag Connector > PROCEDURE

• Side airbag connector AIRBAG SYSTEM > Airbag Connector > PROCEDURE

• Seat heater connector (model with seat heater)

• Power seat connector (model with power seats)

4. Remove the seat belt inner - front.

(1) Remove the nut, and remove the seat belt inner - front.

(2) Remove the clip for the inner seat belt harness located under the seat cushion.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Removal

3. ADJUSTER ASSEMBLY - SEAT BELT

CAUTION:

• The airbag system is fitted with a backup power supply. After disconnecting the battery ground cable, the airbag may operate if you do not wait for 60 seconds before starting the service of airbag system.

• Do not drop or subject the pretensioner to any impact.

• Since the pretensioner and bracket are integrated as a unit, do not disassemble them.

1. Before working, turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 60 seconds or more.

2. Tilt the backrest assembly forward and move the front seat to the front most position.

3. Release the claws, and then remove the cover side sill - front INN.

CAUTION:

Do not pull with excessive force. Doing so may damage the claws of the cover side sill - front INN.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Removal

4. Remove the rear seat cushion assembly.

(1) Push the corners of the rear seat cushion from above.

(2) While pushing the corners of the rear seat cushion from above, pull the knob of the hook - seat cushion rear towards yourself.

(3) While pulling the knob towards yourself, disconnect the hooks by lifting up the rear seat cushion.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Removal

(4) Remove the hook (A) by pushing it back while lifting the front side of the rear seat cushion, and remove the rear seat cushion.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Removal

5. Release the clips and claws, and then remove the cover side sill - rear INN.

CAUTION:

Do not pull with excessive force. Doing so may damage the claws of the cover side sill - rear INN.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Removal

6. Remove the trim panel - center pillar LWR.

(1) Release the clip by pulling the trim panel - center pillar LWR toward you.

(2) Expand the claws of the trim panel - center pillar LWR outward, and remove it from the trim panel - center pillar UPR.

CAUTION:

Do not expand the trim panel - center pillar LWR excessively. Doing so may damage the trim.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Removal

NOTE:

First release the claw located to the front of the vehicle.

7. Remove the trim panel - center pillar UPR.

(1) Remove the cover through (a), and remove the seat belt anchor bolt.

(2) Remove the bolt on the lower side of the trim panel - center pillar UPR.

(3) Remove the clip by pulling the upper part of the trim toward you, and while lowering the entire trim, remove the trim panel - center pillar UPR.

CAUTION:

Do not reuse the upper clips of the trim panel - center pillar UPR. Once the clip is removed, its holding force is reduced. Be sure to replace it with a new clip.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Removal

8. Remove the bolts, and then remove the adjuster assembly - seat belt.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Removal

    2017-02-20 18:50:37    2017-06-19 10:22:09




I advise you to watch 2011 - 2016

© 2018. suforester.com
Order call back