Generation   Home

SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Installation 2015 Subaru Forester

generation: → 2011 - 2016Release year → 2015 ✔ engine size → 2L ✔      add to compare      read later

SEAT BELT SYSTEM > Front Seat Belt

INSTALLATION

1. SEAT BELT OUTER - FRONT

CAUTION:

• The parts of the driver and passenger sides are not the same. Before installation, make sure that the correct part is used.

• During installation, make sure that the seat belts are not twisted.

• After installation, make sure that the seat belt can be pulled out and retracted smoothly.

• Make sure that the seat belt harness is not caught anywhere. Wrong harness rooting may cause the harness short from pinch.

• Do not reuse the upper clips of the trim panel - center pillar UPR. Once the clip is removed, its holding force is reduced. Be sure to replace it with a new clip.

1. Before installation, perform a unit inspection of retractor. SEAT BELT SYSTEM > Front Seat Belt > INSPECTION

2. Install the seat belt outer - front.

Tightening torque:

Front seat belt: SEAT BELT SYSTEM > General Description > COMPONENT

3. Install the remaining parts in the reverse order of removal.

NOTE:

Assemble the trim panel - center pillar LWR to the trim panel - center pillar UPR securely.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Installation

4. After installation, check the following points.

• The seat belt is not twisted.

• The seat belt can be pulled out and retracted smoothly.

• The adjuster assembly - seat belt can be moved smoothly.

• Check that the airbag warning light lights up for approximately 6 seconds and then turns off when connecting the battery ground cable and turning the ignition switch to ON.

2. SEAT BELT INNER - FRONT

CAUTION:

• Before installation, make sure that the correct part is used.

• During installation, make sure that the seat belts are not twisted.

• Check that there is no pinching of the seat belt harness. Wrong harness rooting may cause the harness short from pinch.

1. Install the seat belt inner - front.

Tightening torque:

Front seat belt: SEAT BELT SYSTEM > General Description > COMPONENT

2. Locate the seat belt harness and retain it with a harness clip.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Installation

3. Install the seat assembly to the body.

CAUTION:

• The seat mounting bolts differ between the front mounting points and the rear mounting points. Make sure that you are using correct bolts at correct positions.

• Tighten the slide rail installing bolts in the order as shown in the figure, in several steps by gradually increasing the torque until they reach the specified torque.

2015 Subaru Forester SRS Airbag System & Seat Belt System • Seat Belt System • Front Seat Belt • Installation

• Front (bolt A): Washer diameter 22 mm (0.87 in)

• Rear (bolt B): Washer diameter 26 mm (1.02 in)

Tightening torque:

Front seat assembly: 53 N·m (5.40 kgf-m, 39.1 ft-lb)

4. Check that no harness is caught by sliding the seat back and forth.

3. ADJUSTABLE ANCHOR ASSY

Referring to the installation procedure for seat belt outer - front, install the parts in the reverse order of removal.

Tightening torque:

Front seat belt: SEAT BELT SYSTEM > General Description > COMPONENT

    2017-02-20 18:50:37    2017-06-19 10:22:09




I advise you to watch 2011 - 2016

© 2018. suforester.com
Order call back