Generation   Home

General • Periodic Maintenance Services • Engine Oil Filter • Replacement 2013 Subaru Forester

generation: → 2011 - 2016Release year → 2013 ✔ engine size → 2.5L ✔      add to compare      read later

PERIODIC MAINTENANCE SERVICES > Engine Oil Filter

REPLACEMENT

CAUTION:

If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.

1. NON-TURBO MODEL

1. When there is water or dirt on the oil filter installation portion, clean the relevant area by applying air.

2. Remove the oil filter using ST.

ST    18332AA000OIL FILTER WRENCH

2013 Subaru Forester General • Periodic Maintenance Services • Engine Oil Filter • Replacement

3. Clean the oil filter installing surface on the chain cover.

4. Obtain a new oil filter and apply a thin coat of engine oil to the seal rubber.

5. Install the oil filter turning it by hand, being careful not to damage the seal rubber of the oil filter.

6. Tighten more (approx. 3/4 turn) after the seal rubber contacts the chain cover. When using a torque wrench, tighten to 14 N·m (1.4 kgf-m, 10.3 ft-lb).

7. After installation, check the engine oil level, and check there is no leakage. PERIODIC MAINTENANCE SERVICES > Engine Oil > INSPECTION

2. TURBO MODEL

1. Set the vehicle on a lift.

2. Lift up the vehicle.

3. Remove the service hole cover clip located on the under cover.

2013 Subaru Forester General • Periodic Maintenance Services • Engine Oil Filter • Replacement

4. Rotate the service hole cover in the arrow direction.

2013 Subaru Forester General • Periodic Maintenance Services • Engine Oil Filter • Replacementlu

5. Remove the oil filter.

• Oil filter (Black)

Remove using the ST.

ST    18332AA000OIL FILTER WRENCH (OUTER DIAMETER: 68 MM (2.68 IN) FOR OIL FILTER)

• Oil filter (Blue)

Remove using a general tool (65/67 mm 14 Flutes).

2013 Subaru Forester General • Periodic Maintenance Services • Engine Oil Filter • Replacement

6. Clean the oil filter installing surface of cylinder block.

7. Obtain a new oil filter and apply a thin coat of engine oil to the seal rubber.

8. Install the oil filter turning it by hand, being careful not to damage the seal rubber of the oil filter.

CAUTION:

Do not tighten excessively, or oil may leak.

• Tighten the oil filter (Black) with an outer diameter of 68 mm (2.68 in) (approx. 1 rotation) after the seal rubber of the oil filter comes in contact with cylinder block. When using a torque wrench, tighten to 14 N·m (1.4 kgf-m, 10.3 ft-lb).

• Tighten the oil filter (Blue) with an outer diameter of 67.4 mm (2.65 in) (approx. 7/8 rotation) after the seal rubber of the oil filter comes in contact with cylinder block. When using a torque wrench, tighten to 12 N·m (1.2 kgf-m, 8.9 ft-lb).

9. Return the service hole cover to its original position.

10. Check the engine oil level. PERIODIC MAINTENANCE SERVICES > Engine Oil > INSPECTION

11. Lower the vehicle.

    2017-02-20 18:50:32    2017-05-11 10:18:46




I advise you to watch 2011 - 2016

© 2018. suforester.com
Order call back