Generation   Home

Body & Electrical • Instrumentation/Driver Info • Multi-Function Display (Mfd) System • Operation 2015 Subaru Forester

generation: → 2011 - 2016Release year → 2015 ✔ engine size → 2L ✔      add to compare      read later

INSTRUMENTATION/DRIVER INFO > Multi-function Display (MFD) System

OPERATION

1. DIAGNOSTIC MODE (HIGH GRADE TYPE ONLY)

The settings of the multi-function display can be changed by performing the following procedures to display the diagnostic mode.

CAUTION:

• Perform the work with IG-ON while charging the battery.

• While performing the work, close the front hood and all doors, and do not operate any electrical parts.

• Display can not be switched to diagnostic mode if the illumination control dial is set to the position for the dimming cancel function (maximum brightness).

1. Procedure

CAUTION:

Perform the steps described in (2) through (4) within 10 seconds.

(1) Within 3 seconds after turning the IG-ON, turn the lighting switch to Switch 1 (TAIL) or Switch 2 (HEAD).

(2) While keeping the lighting switch to Switch 1 (TAIL) or Switch 2 (HEAD) position, press the i/SET switch three times.

(3) Turn the lighting switch to OFF, and press the i/SET switch three times.

(4) Turn the lighting switch to Switch 1 (TAIL) or Switch 2 (HEAD) position again, press the i/SET switch three times.

NOTE:

• Except for the demonstration display setting of the diagnostic mode, the display will terminate with IG-OFF or by selecting “Back” from the menu screen.

• The demonstration display setting of the diagnostic mode will terminate by starting the engine or removing the battery. Even if it becomes IG-OFF then IG-ON again, the diagnostic mode will not terminate.

• To select other menus from the demonstration display setting, terminate the diagnostic mode by starting the engine or removing the battery, then access to the diagnostic mode again.

2. Display menu

Change the display and settings from each menu.

Menu

Item

Content

Demonstration display setting

Shows demonstration display.

Vehicle status confirmation

• CAN communication

Displays the connection status of input signals.

• U-ART communication

• Camera connection

Rear camera settings

• Guide line adjustment

Adjust the guide line in the order of up/down, left/right and rotate, then select “Set” to determine.

• Guide line display

Select “ON” or “OFF”, then select “Set” to determine.

• Guide line reset

Select “Yes” or “No” to determine whether to restore to the default settings.

Customize

• Key operation sound

Select “ON” or “OFF”, then select “Set” to determine.

• Correction of lifetime fuel economy value*

Adjust the fuel economy value within the range of -10 — +10 km/l, then determine the value with i/SET switch.

Back

Finish the diagnostic mode.

*: Correction of lifetime fuel economy value is used only when the multi-function display has been replaced. This function is provided as a compensation feature to bring the current lifetime fuel economy value to the one before the replacement of multi-function display.

2. ODO FUEL ECONOMY VALUE RESET (HIGH GRADE TYPE ONLY)

Follow the procedure below to initialize the ODO setting value.

1. Procedure

(1) After IG-ON, pull the i/SET switch toward you for two seconds to display the setting screen.

(2) Select “Factory delivery setting” from “Setting screen”.

(3) Select “ODO setting reset” and determine with “Yes”.

(4) The screen that indicates the completion of the setting is displayed for three seconds. This is the end of operation.

NOTE:

• The resetting operation is confirmed twice. Select confirmation according to the screen.

• The display will terminate with IG-OFF or by selecting “Back” from the menu screen.

    2017-02-20 18:49:06    2017-05-11 10:14:46




I advise you to watch 2011 - 2016

© 2018. suforester.com
Order call back