Generation   Home
Categories
generation

Accessories

Sort by: default name

EyeSight > EyeSight System INSPECTION Refer to “Basic Diagnostic Procedure” of “EyeSight (DIAGNOSTICS)” section. EyeSight (DIAGNOSTICS) > Basic Diagnostic Procedure

EyeSight > Control Unit REMOVAL For removal, refer to the removal procedure of each module. • Engine control module (ECM) Non-turbo model: FUEL INJECTION (FUEL...

EyeSight > Control Unit INSTALLATION For installation, refer to the installation procedure of each module. • Engine control module (ECM) Non-turbo model: FUEL INJECTION...

EyeSight (DIAGNOSTICS) > General Description CAUTION 1. AIRBAG SYSTEM Airbag system wiring harness is routed near the cruise control command switch. CAUTION: • Do not use...

ENTERTAINMENT > Rearview Camera System INSTALLATION CAUTION: Be sure to confirm the marker position, whenever the rearview camera is removed/installed/replaced. Install...

ENTERTAINMENT > Rear Speaker INSTALLATION Install each part in the reverse order of removal. NOTE: If the bracket is removed from the speaker assembly - tweeter, tighten it...

ENTERTAINMENT > Power Amplifier INSTALLATION Install each part in the reverse order of removal. Tightening torque: Power amplifier: 4.5 N·m (0.46 kgf-m, 3.32 ft-lb)

ENTERTAINMENT > Navigation Body INSTALLATION CAUTION: After installing the panel center assembly, check that the air vent grille of the panel center assembly is inserted...

ENTERTAINMENT > GPS Antenna INSTALLATION CAUTION: After installing the panel center assembly, check that the air vent grille of the panel center assembly is inserted...

ENTERTAINMENT > AUX Input Terminal INSTALLATION CAUTION: After installing the panel center assembly, check that the air vent grille of the panel center assembly is inserted...

ENTERTAINMENT > Audio INSTALLATION CAUTION: After installing the panel center assembly, check that the air vent grille of the panel center assembly is inserted correctly...

ENTERTAINMENT > Antenna INSTALLATION Install each part in the reverse order of removal. Tightening torque: Antenna assembly - radio: 4.5 N·m (0.46 kgf-m, 3.3 ft-lb)

CRUISE CONTROL SYSTEM > Cruise Control Module REMOVAL For removal procedures of the control module, refer to “FUEL INJECTION (FUEL SYSTEMS)”. • Non-turbo model: FUEL...

CRUISE CONTROL SYSTEM > Cruise Control Module INSTALLATION For installation procedures of the control module, refer to “FUEL INJECTION (FUEL SYSTEMS)”. • Non-turbo model:...

SPEED CONTROL SYSTEMS(H4DO) > General Description CAUTION • Prior to starting work, pay special attention to the following: 1. Always wear work clothes, a safety cap,...

SECURITY AND LOCKS > Keyless Entry System INSPECTION 1. SYMPTOM CHART Symptoms Repair order Reference None of the functions of the keyless entry system...

SECURITY AND LOCKS > Keyless Buzzer INSTALLATION 1. Install each part in the reverse order of removal. Tightening torque: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb) 2. Adjust the fog...

SECURITY AND LOCKS > Immobilizer Antenna INSTALLATION Install each part in the reverse order of removal.

EXTERIOR/INTERIOR TRIM > Trailer Hitch INSTALLATION Install each part in the reverse order of removal. Tightening torque: Refer to “COMPONENT” of “General Description”....

ENTERTAINMENT > Tweeter INSTALLATION Install each part in the reverse order of removal.

ENTERTAINMENT > Steering Satellite Switch INSTALLATION Install each part in the reverse order of removal.

ENTERTAINMENT > Rearview Camera System INSTALLATION CAUTION: • If the urethane foam of connector is removed during removal, be sure to apply new urethane foam. • Be sure...

ENTERTAINMENT > Navigation Body PROCEDURE For the removal and installation operation procedures of navigation unit, refer to the removal and installation procedures of the...

ENTERTAINMENT > Microphone PROCEDURE Refer to “Spot Map Light” for removal and installation procedures of microphone. LIGHTING SYSTEM > Spot Map Light
© 2018. suforester.com
Order call back